User Manual

Page 7
RC-955Display
1. Bright,2-digitLEDdisplay.(180°Rotating)
2. Displaysthepoweredlinestatusreceived
 fromthetransmitter.
3. “0-99”numericindicationof
 signalstrength.
4. Indicatorlightswhenaudibletone
 isdisabled.
5. Peakdetectorshowsinstantaneous
 changesinsignalstrength.
RC-959Display
1. Super-brightOLEDdisplay(90°rotating).
2. Displaysthepoweredlinestatusreceived
 fromthetransmitter.
3. IndicatesOn/Offstatusofthe
 audibletone.
4. LowBatteryIndicator.Flashes
 when10%batteryliferemains.
5. “0-99”numericindicationofsignalstrength.
6. Displaysthesensitivitysetting.
7. Peakdetectorshowsinstantaneouschangesinsignalstrength.
AdditionalNotes
• Sensitivitymodeselection–generalguidelines:
 • Startoutatmaximumsensitivity()untilthereceiverfindsthecircuitunder
test.Ifthereceiveristoosensitive,thenreducethesensitivityusingthe
  buttonuntilthereceiver’sdisplaydoesnotpegat“99”continuously.
 • Usemodefortracing:(a)inclosedcircuitswhileusingtheoutletplug
adapter(ratherthanthe25’leadandaremotereturnpathsetup),(b)inopen
circuits,(c)underground,(d)andanywhereelsemoresignaldetectionisneeded.
 • Usemodetoreducethelevelofsensitivityifthehighestsensitivityrange
hassignalsaturation(displayispeggingat“99”continuously).
 • Usemodefortracing(a)inclosedcircuitswhileusingthe25’leadanda
remotereturnpath,(b)andwhenpreviousmodehassignalsaturationof“99.”
 • UseBreakermodefor(a)identifyingcircuitbreakersandfuses,(b)
pinpointingindividualwiresfromabundle,(c)andwhenpreviousmodehas
signal saturation.
1
4
2
5 6 7
3
1 42
5
3