User Manual

Receiver:
1) Removethebatterycapbylooseningthescrew.
2) Replacebatterieswith(3)newAAbatteries.
3) Re-fitcapandre-tightenthescrew.
BatteryPackforInductiveClamp:
Ensuretheclampisunpluggedfromthe
batterypack.
1) Removecapbysqueezingtheribbedtabson
 eithersideofthecap.
2) Removethebatteryholdernotingthe
 orientationtothestrapmountonthecase.
3) Replacebatterieswith(8)newC-cellbatteries.
4) Re-installbatteryholderintothecasenoting
 theorientationtothemagneticstrapmount.
5) Snapcapbackontocase.
Fuse Replacement (TR-955only)
Ifthefollowingsymptomsareexhibited,theinternalprotectionfuseshouldbecheckedand
replaced:
 •Thetransmitterappearstopowerupnormallybutsignaloutputiszero,orgreatlydiminished.
 •Whenconnectedtoalivecircuit,theindicatordoesnotlight.
 •Thereceiverstillindicatesastrongreadingwhenplacedincloseproximitytothetransmitter.
WARNING
Toavoidpersonalinjuryordamagetothetransmitter,useonlytheIDEALfusespecifiedin
thismanual.
Ensurethatthetestleadsareremovedfromtheoutputjacksandthecircuitundertest.
1) Removethebatterycapandbatteriesasdescribedabove.
2) Unscrewthe(6)retainingscrewsfromtherearsectionofthecaseandremove.
3) Thefuseislocatedattheconnectorend.ReplacewithIDEALpart#F-956.
4) Replacethecaserearsectionandscrews,batteriesandbatterycap.
Page 21
Ribbed Tabs
Strap Mount
Strap
Mount
Ribbed
Tabs