User Manual

Page 19
Identifyingdownstreamloadsfromabreaker.
1) Removethepanelcoverandclamparoundthehotwireoftheenergized(closed)circuit.
 • Tomaximizethesignal,closethefarendofthecircuitbyplugginginandturning
   onaworklightorotherloadintothefurthestoutlet;hence,makingacomplete
loop.
2) Hangthebatterypackontothepanelwiththemagneticstrap.
3) Plugtheclampintothebatterypack.
4) Setthereceivertothehighestsensitivitymode()andtracethecircuittothefurthest
outletwhileidentifyingalloutletsandloadsconnectedtothecircuit.IftheReceiveris
 saturated,reducethesensitivityrange.
TracingConduit.
1) Clamparoundthemetallicconduittobetraced.Ifpossible,groundthefarendofthe
conduittoclosetheloop.Thiscanbecreatedusingthe25’leadandalligatorclipstoclip
ontotheendoftheconduitorelectricalboxwithoneclipandaremoteneutralorwater
pipewiththeotheralligatorclip.
2) Hangthebatterypackontothepanelorconduitwiththemagneticstrap.
WeakerSignal-Open
StrongerSignal-Closed
LightOn
(Load)
Breaker
Energized
Breaker
Energized