User Manual

Page 16
Sorting Bundled Wires
Applicationsincludeidentifyingaspecificcircuitamongstseveralcircuitsinafilled
conduit,sortingwiresinawireharness,identifyingcoaxcableandtwistedpaircableina
terminationbox.
1) Connectthetransmittertothecircuittobetracedandpoweriton.
 a) Cliponetestleadtotheknownendofthewiretobetracedoridentified.
 b) Cliptheothertestleadtoaremotereturnpath.
2) Turnonthereceiverandsetittotheleastsensitivity().
3) Gototheotherendofthewirerunandsortouttheindividualwireusingthenoseof
thereceiver.
 a) Ifthesignalistoostrong,separatethewiresmorefromthebundlewhentesting.
 b) Ifthesignalistooweak,thenincreasethesensitivityrangeonthereceiverand
repeatstep#3.
4) Continuesortinguntilthewirewiththehighestreadingisidentified.