Use and Care Guide

Form number TM61773-5 Rev 3 July 2010
Page 2
High Voltage Warning (HI-V):
The meter beeps and lights an LED when >30V AC/DC voltage is present through test leads of
the meter. This enhanced safety feature alerts the user that dangerous voltage is present across the
leads even if the meter is set on an incorrect function or range.
Notes: This feature does not work through the clamp head as the clamp is intended to only
measure current. Audible indication can be turned off by pressing and holding the MAX/MIN
button while turning the function switch from OFF to the desired range position.
SAFETY
Review the following safety precautions to avoid injury and prevent damage to this product or any products
connected to it. To avoid potential hazards, use the product only as specified.
CAUTION.
These statements identify conditions or practices that could result in damage to the equipment or other
property.
WARNING.
These statements identify conditions or practices that could result in personal injury or loss of life.
Specific precautions
Do not operate without covers. To avoid personal injury, do not apply any voltage or current to the
product without the covers in place.
Electric overload. Never apply a voltage to a connector on the product that is outside the range specified
for that connector.
Avoid electric shock. To avoid injury or loss of life, do not connect or disconnect probes or test leads
while they are connected to a voltage source.
Do not operate in wet/damp conditions. To avoid electric shock, do not operate this product in wet or
damp conditions.