Instructions / Assembly

STEP 8: When finished, remove any dust or particles that may have
become attached to the blade.
STEP 7: To cut several small cables continuously, cut first cable as
described above, then reversed blade until opening is sufficient to
feed the next cable through. Continue to alternate between forward
and reverse modes until all cables are cut (Figure 7).
STEP 6: Press the drill trigger switch until cable is completely cut.
Reverse mode on drill can be used to back off blade if necessary.
STEP 5: Place the cable to be cut onto the stationary blade and close
the moving blade around the cable. Feed the moving blade by hand
until the first gear teeth are engaged. (Figure 5 and 6).
STEP 1: Attach cable cutter drive shaft to drill as shown (Figure 1).
Tighten drill chuck securely.
STEP 2: Move handle from closed to extended position. (Figure 2).
STEP 3: Loop torque arm around drill handle and tighten handle into
locking collar to lock torque arm and handle in place (Figure 3). Do
not operate tool without torque arm in place.
STEP 4: Activate the drill trigger switch to the moving blade
(Figure 4).
Figure 1
Figure 2
Figure 3
Figure 4
Figure 7
Figure 6
Figure 5
Operating Instructions
Blade Replacement, Parts and Accessories
Blade Replacement (See exploded view above)
Your Drill-Powered Cable Cutter unit is designed for easy blade
replacement. If blade damage occurs that cannot be filed away, or if
blades are accidentally used on steel or ACSR, replace both blades
as described below:
1. Disconnect drill from power source or battery, then detach unit
from drill. Do not attempt blade replacement with drill attached.
2. Remove four hex screws from end cap that sits on top of the fixed
blade using a
5
⁄329 hex wrench (Figure 8).
3. Remove end cap from unit (Figure 9).
4. Remove 6 hex screws attaching blade to body, using a
1
⁄89 hex
wrench (Figure 10).
5. Remove blade assembly.
6. Replace with a new blade set, IDEAL part #K-8906R.
7. Reinstall using screws removed earlier.
Always replace blades in sets for optimal performance. Replacing
only one side will increase war and shorten overall blade life.
Warranty
One year limited warranty. Warranty limited solely to repair or
replacement; no warranty of merchantability, fitness for a particular
purpose or consequential damages. 90 day warranty on blades.
Handle Replacement
The comfort handle can be unscrewed and replaced if necessary.
Order IDEAL replacement hand part #H-3507. Replacement torque
arm assemblies can also be ordered. IDEAL part #K-8933 includes
torque arm, locking collar and roll pin.
ITEM NO. PART NO. DESCRIPTION QTY.
1 — End Cap 1
2
K-8906R
Blade Pair Assembly 1
3
K-8933
Torque Arm 1
4
H-3507
Folding Handle 1
5
281.106
.125 Dia x .625 Roll Pin 1
6
113.191
10-32 x .500 SHCS Hex Screw 4
7
633.059
#10 Split Lock Washer 4
8
113.190
10-32 x .375 FHMS Hex Screw 6
9
H-3400
Gearbox Assembly 1
10
KB-0456
Drive Gear 1
—
ND-5242
Carrying Case 1
Figure 9
Figure 8
Figure 10
3
Torque Arm
5
Roll Pin
4
Folding Handle
End Cap
1
7
6
Screws to Remove
End Plate
9
Gearbox Assembly
8
Screws to Remove
Fixed Blade
2
Blade
Assembly
10
Drive Gear