Install Instructions

11
Step 2 – Strip
Strip off 2 inches of outer jacketing of cable.
Avoid damaging or nicking of the pairs.
Step 3 – Wiring Configuration
Determine the wiring configuration to use. Separate the pairs and
insert them into the colored slots. The jack will have both wiring
codes printed on it. No more than
1
⁄2 inch of each pair should be
left untwisted.
Step 4 – Terminate
Terminate the wires into the slots on the jack by using a punchdown
tool as shown. Make sure cutting edge of blade is on outside of jack.
Terminating a Data Jack
USE LOW IMPACT SETTING FOR JACKS
Score cable with stripper
CAT. NO. 45-165
Bend cable, remove jacket
T568A
or
T568B
Terminated Jack
Step 1 – Cutting
Aciduis num do odolendigna
CAT. NO. 30-496