Specification

Clear Glide
TM
Wire Pulling Lubricant
SDS#: ID006
Revision Date: August 11, 2016 Page 5 of 10
Respiratory protection: None normally required. Where protection from nuisance levels
of dusts are desired, use type N95 (US) dust masks. Use respirators and components tested
and approved under appropriate government standards such as NIOSH/OSHA.
Other: None required.
Thermal hazards: No data available.
SECTION 9: Physical and chemical properties
Appearance
Physical state: Gel
Form: Clear, colorless gel.
Color: Colorless.
Odor: Slight odor.
Odor threshold: No data available
pH: 7.0 - 8.0
Melting point/freezing point: No data available
Initial boiling point and 212
o
F (100
o
C)
boiling range:
Flash point: None
Evaporation rate: No data available
Flammability (solid, gas): Not applicable
Upper/lower flammability or explosive limits
Flammability limit – lower %): Not applicable
Flammability limit – upper (%): Not applicable
Explosive limit – lower (%): Not applicable
Explosive limit – upper (%): Not applicable
Vapor pressure: No data available
Vapor density: No data available
Relative Density: 1.09
Solubility(ies): Infinite in water.
Partition coefficient (n-octanol/water): No data available
Auto-ignition temperature: No data available
Decomposition temperature: No data available
Viscosity: 25300-40300 cps
Other information:
% Volatile by volume: < 98%
Volatile Organic Compounds (VOC) 17.4 gms/ltr
(as packaged, minus water)
Percent solids by weight: ~ 5%
SECTION 10: Stability and Reactivity
Reactivity: Not chemically reactive.