SDS

Aqua-Gel
®
CW Wire Pulling Lubricant
SDS#: ID003
Revision Date: June 7, 2015 Page 4 of 10
"Empty" containers retain residue and may be dangerous. "Empty" drums should be
completely drained, properly bunged, and promptly shipped to the supplier or a drum
reconditioner. All containers should be disposed of in an environmentally safe manner and in
accordance with governmental regulations.
SECTION 8: Exposure controls/personal protection
Control Parameters:
Occupational exposure limits:
US OSHA HAZARDOUS COMPONENTS (29 CFR 1910.1200):
Permissible Exposure Limits
Substance
PEL-TWA
(8 hour)
PEL-STEL
(15 min)
Potassium Hydroxide
No data available
No data available
US ACGIH Threshold Limit Values
Substance
TLV-TWA
(8 hour)
TLV-STEL
(15 min)
Potassium Hydroxide
2 mg/m
3
Ceiling
No data available
NIOSH Exposure Limits
Substance
TWA
STEL
Potassium Hydroxide
2 mg/m
3
Ceiling
No data available
Appropriate engineering controls: General (mechanical) room ventilation is expected to be
adequate. Special local ventilation is suggested at points where vapors can be expected to
escape to the workplace air or in enclosed areas.
Individual protection measures, such as personal protective equipment:
Eye/face protection: None normally required, but the use of OSHA compliant safely
glasses or splash goggles recommended.
Skin and Hand protection: None normally needed -Neoprene if necessary. Gloves must be
inspected prior to use. Use proper glove removal technique (without touching glove's outer
surface) to avoid skin contact with this product. Dispose of contaminated gloves after use in
accordance with applicable laws and good laboratory practices. Wash and dry hands.
Respiratory protection: None normally required.
Other: Eye wash / eye bath in the work area is recommended but not necessary.
Thermal hazards: No data available.
SECTION 9: Physical and chemical properties