User manual

If the pilot light 9 remains lit, this means that
the machine is already heating or that the
water level is too high. In any case, do not try
to force the door!
If you cannot open the door but you need to
open it, you have to switch the machine off
by turning the selector dial to
. After a few
minutes the door can be opened
(Pay attention to the water level and
temperature!).
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 7 .
At the end of the programme
The machine stops automatically. The blink-
ing
appears on the display, the pilot light
of button 7 and the pilot light 9 go off.
If a programme or an option that ends with
water left in the tub has been selected, the
pilot light 9 remains on and the door is locked
to indicate that the water must be emptied
out before opening the door.
Follow the below instructions to empty out
the water:
1.
Turn the programme selector dial to
.
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4.
Press button 7 .
At the end of the programme, the door is re-
leased and can be opened. Turn the pro-
gramme selector dial to
to switch the ma-
chine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleasant
smells.
Stand By : If your laundry is not removed
within 10 minutes after the programme is fin-
ished, the back light of the display switches
off and the energy saving system will be en-
abled. Only the pilot light of the button 7 is
blinking to indicate that the appliance has to
be switched off. By pressing any button the
appliance will come out from the energy sav-
ing status and you can set another pro-
gramme or switch the appliance off.
Care and cleaning
Warning! You must DISCONNECT the
appliance from the electricity supply,
before you can carry out any cleaning or
maintenance work.
Descaling
The water we use normally contains lime. It
is a good idea to periodically use a water
softening powder in the machine. Do this
separately from any laundry washing, and
according to the softening powder manufac-
turer's instructions. This will help to prevent
the formation of lime deposits.
External cleaning
Clean the exterior cabinet of the appliance
with soap and water only, and then dry thor-
oughly.
Cleaning the drawer recess
The washing powder and additive dispenser
drawer should be cleaned regularly.
Remove the drawer
by pressing the
catch downwards
and by pulling it out.
Flush it out under a
tap, to remove any
traces of accumula-
ted powder.
To aid cleaning, the
top part of the addi-
tive compartment
should be removed.
13