User manual

Personalisation
Acoustic signals
The machine is provided with an acoustic
device, which sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the 4 and 5 buttons simultane-
ously for about 6 seconds , the acoustic
signal is deactivated (except if there is a fault).
By pressing these 2 buttons again, the
acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appli-
ance unattended and not to worry that chil-
dren might be injured by or cause damage to
the appliance. This function remains enabled
also when the washing machine is not work-
ing.
There are two different ways to set this op-
tion:
1.
Before pressing button 7 : it will be im-
possible to start the machine.
2. After pressing button 7 : it will be impos-
sible to change any other programme or
option.
To enable or disable this option press simul-
taneously for about 6 seconds buttons 2 and
3 until on the display, the icon
appears or
disappears.
Daily use
Load the laundry
Open the door by
carefully pulling the
door handle out-
wards. Place the
laundry in the drum,
one item at a time,
shaking them out as
much as possible.
Close the door.
Measure out the detergent and the
fabric softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent re-
quired, pour it into the main wash com-
partment
or in the appropriate com-
partment if the selected programme/op-
tion it requires (see more details in "Deter-
gent dispenser drawer").
If required, pour fabric softener into the
compartment marked
(the amount used
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
Select the required programme by
means of the programme selector dial
(1)
Turn the programme selector dial to the re-
quired programme.
The green pilot light of button 7 starts to
flash. The selector dial can be turned either
clockwise or anticlockwise.
Turn the selector dial to position
to reset
the programme/to switch the machine OFF.
At the end of the programme the selec-
tor dial must be turned to position
, to
switch the machine off.
Important! If you turn the programme
selector dial to another programme when the
machine is working, the red pilot light of
button 7 will blink 3 times and the message
Err is displayed to indicate a wrong
selection. The machine will not perform the
new selected programme.
Select the spin speed by pressing button
2
When selecting a programme, the appliance
proposes automatically the maximum spin
speed provided for that programme. (See
"Washing programmes" for the maximum al-
lowed spin speed).
Press this button repeatedly to change the
spin speed, if you want your laundry to be
spun at a different speed. The relevant pilot
light illuminates.
11