User manual

For better drying results, keep the ap-
pliance door ajar for some minutes.
• If you do not switch off the appli-
ance, after three minutes from the
end of the washing programme:
– all indicator lights go off,
– the display shows one horizontal
bar,
This helps to decrease energy con-
sumption.
Press one of the buttons (not the on/off
button), the display and the indicator
lights come on again.
Remove the items from the baskets
• Let the dishes become cold before you
remove them from the appliance. Hot
dishes can be easily damaged.
• First remove the items from the lower
basket, then from the upper basket.
• There can be water on the sides and on
the door of the appliance. Stainless steel
becomes cool more quickly than the
dishes.
CARE AND CLEANING
To remove and clean the filters
Dirty filters decrease the washing results.
1 2
Clean the filters be-
low running water.
3
To remove filters B
and C, turn the
handle approxi-
mately 1/4 counter-
clockwise .
4
Remove the flat fil-
ter A from the bot-
tom of the appli-
ance.
5
Put the flat filter A
in the bottom of the
appliance. Install
the flat filter cor-
rectly under the
two guides D.
6
Put the filter system
in position. To lock
the filter system,
turn the handle
clockwise until it
locks in position.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance
and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents (acetone).
WHAT TO DO IF…
The start of the appliance does not occur
or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the serv-
ice centre.
With some malfunctions, the display
shows an alarm code:
•
- The appliance does not fill with wa-
ter
•
- The appliance does not drain the
water
12