Dishwasher IZDF4010
CONTENTS Safety information Control panel Washing programmes Use of the appliance Setting the water softener Use of dishwasher salt Use of detergent and rinse aid Multitab function 2 4 5 6 6 8 8 9 Loading cutlery and dishes 9 Setting and starting a washing programme 11 Care and cleaning 12 What to do if… 12 Technical data 14 Environment concerns 15 Installation 15 Subject to change without notice Before the installation and use, read this manual carefully: • For your safety and the safety of your propert
• Make sure that the spray arms can move freely before you start a washing programme. • The appliance can release hot steam if you open the door while a washing programme operates. There is a risk of skin burns. • Do not remove the dishes from the appliance until the washing programme is completed. Let the water flow for some minutes, then connect the inlet hose. • Make sure not to squash or cause damage to the water hoses when you install the appliance.
Warning! The dishwasher detergents are dangerous and can cause corrosion ! • If an accident occurs with these detergents, contact immediately a physician. • If the detergent gets into the mouth, contact immediately a physician. • If the detergent gets into the eyes, contact immediately a physician and clean the eyes with water. • Keep dishwasher detergents in a safe area and out of children touch. • Do not keep the appliance door open when there is detergent in the detergent dispenser.
On/off button Press this button to activate or deactivate the appliance. Delay start button Press this button again and again to delay the start of the washing programme from 1 to 19 hours. Programme buttons Press one of these buttons to set a washing programme. The related indicator comes on. Refer to 'Washing programmes'. Display The display shows: • The electronic adjustment of the level of the water softener. • Activation/deactivation of the rinse aid dispenser (only with multitab function on).
Programme Type of soil Type of load Programme description Use this programme to quickly rinse the dishes. This prevents the remaining food to bond on the dishes and bad odours to come out from the appliance. Do not use detergent with this programme Rinse 1) The appliance senses the type of soil and the quantity of items in the baskets. It automatically adjusts the temperature and quantity of the water, the energy consumption and the programme time.
Water hardness adjustment Water hardness German degrees (°dH) French degrees (TH°) mmol/l Clarke degrees manually electronically 43 - 50 76 - 90 7,6 - 9,0 53 - 63 2 1) 9 37 - 42 65 - 75 6,5 - 7,5 46 - 52 21) 8 29 - 36 51 - 64 5,1 - 6,4 36 - 45 21) 7 23 - 28 40 - 50 4,0 - 5,0 28 - 35 21) 6 51) 19 - 22 33 - 39 3,3 - 3,9 23 - 27 21) 15 - 18 26 - 32 2,6 - 3,2 18 - 22 1 4 11 - 14 19 - 25 1,9 - 2,5 13 - 17 1 3 4 - 10 7 - 18 0,7 - 1,8 5 - 12 1 2 <4 <7 < 0,7
USE OF DISHWASHER SALT 2 1 6 5 It is correct that water comes out from the salt container when you fill it with salt. 3 Fill the salt container with 1 litre of water (only for the first time you fill with salt). 4 USE OF DETERGENT AND RINSE AID 1 2 30 3 Do these steps to fill the detergent dispenser: 1. Press the release button 2 to open the lid 7 of the detergent dispenser. 2. Put the detergent in the dispenser 1 . 3.
Use of rinse aid Rinse aid makes it possible to dry the dishes without streaks and stains. The rinse aid dispenser automatically adds rinse aid during the last rinsing phase. Do these steps to fill the rinse aid dispenser: 1. To open the rinse aid dispenser, turn the cap 4 counterclockwise 2. Fill the rinse aid dispenser 5 with rinse aid. The mark 'max' shows the maximum level. 3. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during the washing programme. 4.
• Water droplets can collect on plastic items and non-stick pans. 1 Arrange the service dishes and large lids around the edge of the basket. 2 1 Arrange the items to let water touch all surfaces. 2 For longer items, fold the cup racks up. Prevent to put plates in the first three sectors in the front part of the basket. Make sure the plates tilt forward. Adjustment of the height of the upper basket You can put the upper basket in two positions to increase the load flexibility.
Caution! • Do not lift or lower the basket on one side only. • If the basket is in the upper position, do not put cups on the cup racks. SETTING AND STARTING A WASHING PROGRAMME Select and start a washing programme without delay start 1. Switch on the appliance. 2. Make sure that the appliance is in setting mode. 3. Select a washing programme. Refer to 'Washing programmes'. – The related programme indicator light comes on. – All other programme indicator lights go off.
For better drying results, keep the appliance door ajar for some minutes. • If you do not switch off the appliance, after three minutes from the end of the washing programme: – all indicator lights go off, – the display shows one horizontal bar, This helps to decrease energy consumption. Press one of the buttons (not the on/off button), the display and the indicator lights come on again. Remove the items from the baskets • Let the dishes become cold before you remove them from the appliance.
• Warning! Deactivate the appliance before you do the checks. - The anti-flood device is on. Malfunction The appliance does not fill with water. The appliance does not drain the water. Possible cause The water tap is blocked or there is limescale on it. Clean the water tap. The water pressure is too low. Contact your local water authority. The water tap is closed. Open the water tap. The filter in the water inlet hose is blocked. Clean the filter.
Problem Possible cause Possible solution The spray arms could not turn freely because of incorrect arrangement of the load. Make sure that an incorrect arrangement of the load does not cause a blockage of the spray arms. The filters are dirty or not assembled and installed correctly. Make sure that the filters are clean and correctly assembled and installed. The quantity of detergent was not sufficient or missing. Make sure that the quantity of detergent is sufficient. The salt container is empty.
Depth Water supply pressure 610 mm Minimum 0.5 bar (0.05 MPa) Maximum 8 bar (0.8 MPa) Water supply 1) Cold water or hot water Capacity Place settings maximum 60 °C 12 1) Connect the water inlet hose to a water tap with a 3/4'' thread. The rating plate on the inner edge of the appliance door shows the electrical connection data. photovoltaic panels and aeolian), use a hot water supply to decrease energy consumption. If the hot water comes from alternative sources of energy, (e.g.
Water drain connection max 400 cm max 85 cm min 40 cm 1 Connect the water drain hose to the sink spigot. 3 16 2 4 The drain hose extension must not be longer than 2 m. The internal diameter must not be smaller than the diameter of the hose. If you connect the water drain hose to a trap spigot under the sink, remove the plastic membrane (A).
156958170-A-342011
