Switzerland TEK-SCOPE PLUS User Manual www.ideal-tek.
Switzerland INDEX System information 3 Assembly 3 Use with a monitor 4 - Remote control 4 - Remote control pairing 5 - TEK-SCOPE live streaming 5 - 4D LENS 5 Use with a PC 5 - TEK-SCOPE software 5 - Toolbar 6 - Draw Mode Toolbar 6 - Setting menu 7 - System set up 8 - Measuring 8 - Calibration 8 - Ethernet 9 Optional accessories 9 - TEK-TILT-PLUS 9 - TEK-XY 9 Technical facts 10 Safety information 10 Warranty 10 Contact 10 www.ideal-tek.
Switzerland SYSTEM INFORMATION TEK-SCOPE PLUS is a standalone high definition optical inspection system. The camera system has the following functions: • Auto Focus On/Off • Adjustable focus • Digital Zoom ON/OFF • LED lights • Monitor connection via DisplayPort / HDMI port • Direct image Storage on USB memory stick • PC Connection Software via micro USB / USB por • Measurement & drawing capabilities TEK-SCOPE can be connected to any monitor with a DisplayPort / HDMI port.
Switzerland USE WITH A MONITOR Remote control Use the remote control when the device is connected to the monitor. Z+ Zoom in (+) Z- Zoom out (-) 4Increase brightness 3Decrease brightness Press FUNC shortly and autofocus will go off / on. When autofocus is off, 3&4 will adjust focus manually. OK changes magnification to wide angle and shows an artificial white cross. Press OK again to exit and go back to previous magnification. Press MODE to change between color and greyscale.
Switzerland *IMPORTANT: exactly set your monitor diagonal before start working to obtain a correct magnification value Remote control pairing Hold the remote control on the back of the TEK-SCOPE PLUS while the power is on, then press the OK button on the remote control for 5 seconds. When a red light start flashing, the pairing procedure is complete. Note: The remote control inside the package is paired by the Factory.
Switzerland After installing the Software, you can access TEK-SCOPE PLUS functions: Toolbar Zoom in / out Record video (microphone requested) Save, Save as images Lock - Unlock autofocus Adjust manual focus Show Crosshair Freeze /Unfreeze image Color / Greyscale Digital Zoom ON / OFF Draw mode (measurements, image comparison, etc.) Setting menu Full screen image Save presets (Zoom value). Right click to set, left click to recall Draw Mode Toolbar Draw a rectangle. No measure valuesDraw a circle.
Switzerland Open a saved image to make live comparison Full screen (Default) Compare Live image with stored images (horizontally and vertically) Overlay, compare live image and stored image Zoom IN on the editing image Calibration: use calibration to get more accurate values Settings Go back to live image Text Press T button and click on the part of your image where you want to add text .
Switzerland Zoom value / rotation: how much the zoom moves vs. the scroll wheel Editing Colors: change the color of text and drawings in the Draw Mode System set up Example of system setup when TEK-SCOPE PLUS Software is used: DO NOT CONNECT THE DEVICE BOTH TO A MONITOR AND PC TOGETHER. If the computer and the monitor are used together, like extended or dual, the algorithm for magnification/ measuring will be effected.
Switzerland ETHERNET Connect an Ethernet cable to your system and your network will give the system an IP address, this address can be found either in the menu OSD or under settings in the software. This address can be used in Google Chrome browser on every device connected to the same network domain to show a live picture. IMPORTANT: Edge & Firefox browsers are currently not supported by this unit.
Switzerland TECHNICAL FACTS Magnification 27” monitor: 46x optical (bigger monitor size results in increased optical magnification) up to 460x digital (92x recommended) Autofocus and manual focus Free working distance under camera : 310mm Resolution: FHD on monitor, 1920 x 1080 On screen magnification rate Sensor: 1.
