Data Sheet

5
PCSA Circuit board holder
How to use PCSA detachable assembly
jigs fo pc board
PC Assembly jig with component-press lid
closed screwed or clamped to work-top, in
relation to the height of the components.
Sliding rails may be positioned by means
of self-locking sleeves. A system of sprin-
gs makes it possible to insert and remove
printed circuit boards without changing
position of sleeves.
Moveable couplings, located on the rear
side of the assembly jigs for attaching
the PC assembly jig to the frame. These
couplings keep the PC assembly jig from
detaching from the frame.
Positioning of the lower
corners of the PC Assem-
bly Jig in the toothed gui-
des located on the frame.
Positioning at 80° angle Positioning at 90° anglePositioning at 70° angle
Turn the knob to remove the middle bri-
dge.
Practical use of PC Assembly Jig with PC Board in place. Unsoldering of components carried out with PC Assembly
Jig in vertical positions.
Foam rubber-lined lid for holding compo-
nents in place. May be raised by applying
pressure to front buttons.
Easy to unslot and detach various parts.
(Frame-PC holder unit-component-Press
Lid).
PC board assembly jig can be raised by tur-
ning lateral knobs. Self-adjustment to frame
at right working angle, after unit raising.
Using pc board assembly jig
in vertical position