User manual

HOW TO USE PCSA DETACHABLE ASSEMBLY JIGS FOR PC BOARDS
USING PC BOARD ASSEMBLY JIG IN VERTICAL POSITION
Positioning of the lower corners of the PC
Assembly Jig in the toothed guides located on the
frame.
Positioning at 70° angle Positioning at 80° angle Positioning at 90° angle
PC board assembly jig screwed onto
work top, with component-press lid
down.
Foam rubber-lined lid for holding
components in place. May be raised
once front lock has been released.
Raising of whole PC board assembly
jig unit rotating on its hinge-pin.
Self-adjustment to frame at right
working angle, after unit raising.
Easy to detach PC assembly jig from
frame. Rail positions as for types below.
PC Assembly jig with component-press lid closed
screwed or clamped to work-top, in relation to the
height of the components.
Foam rubber-lined lid for holding components in
place. May be raised by appltying pressure to front
buttons (Anti-static conducting foam rubber for
PCSA types)
Easy to unslot and detach various parts. (Frame-
PC holder unit- component- Press Lid)
PC board assembly jig can be raised by turning
special lateral knobs. Self-adjustment to frame at
right wotrking angle, after unit raising.
Practical use of PC Assembly Jig with PC Board in place.
Unsoldering of components carfried out with PC Assembly Jig in vertical
positions.
Sliding rails may be positioned by means of self-
locking sleeves. A system of springs makes it
possible to insert and removee printed circuit
boards without changing position of sleeves.
CENTRAL RAIL can be pressed into place Moveable couplings, located on the rear side of
the assembly jigs for attaching the PC assembly
jig to the frame. These couplings keep the PC
assembly jig from detaching from the frame should
it be moved in that direction.
PO Box 221, CH-6830 Chiasso 3 Tel. [phone] Fax [phone] [e-mail] www.ideal-tek.com
ideal-tek s.a.