Data Sheet

www.ideal-tek.com

swiss made

Dierent materials available

High-performance plastic type CP

» PEEK polyetheretherketone reinforced with carbon nano

» very hard, rigid, high tensile and exural strength, very high wear resistance

» high heat capability (260-300°C), good dimension stability, low thermal linear expansion coecient

» excellent resistance to chemicals and aggressive agents, excellent resistance to thermal ageing

» ESD-safe material 10

Ohm

» typical applications include handling of components in cleaning/chemical/assembly processes also at high temperature

(soldering)

High performance plastic type SV

» PVDF polyvinylidene uoride carbon bre reinforced

» excellent mechanical strength and toughness

» smooth surface

» heat stabilized, high heat capability, continuous use temperature up to 150°C

» high purity (clean room and medical devices approved, low extraction value)

» excellent chemical resistance to most aggressive substances (mineral and organic acid) and solvents (hydrocarbons,

alcohols, halogenated), resistant to halogens

» outstanding resistance to hydrouoric acid (40% conc., 90°C), nitric acid (50% conc., 90°C), hydrochloric acid (36%

conc., 90°C)

» high abrasion resistant

» resistant to UV and nuclear radiation (sterilisation)

» ESD safe material, (avoid powder attraction, sparks generation, ignition sources)

» typical applications include handling of very scratch- and contamination-sensitive components, cleaning and etching

processes

Engineering plastic type NY

» PA66/GF50 polyamide 66 reinforced with 50 wt% glass bre

» high strength, fatigue, wear and creep resistance

» heat stabilized, good heat capability

» good chemical resistance (oils, grease, fuels, non polar solvents); not resistant to strong acids, alkalis and hot water or steam

» insulative