Datasheet

5
PCSA Circuit board holder
How to use PCSA detachable assembly
jigs fo pc board
PC Assembly jig with component-press lid
closedscrewedorclampedtowork-top,in
relationtotheheightofthecomponents.
Sliding rails may be positioned by means
ofself-lockingsleeves.Asystemofsprin-
gs makes it possible to insert and remove
printed circuit boards without changing
positionofsleeves.
Moveable couplings, located on the rear
side of the assembly jigs for attaching
the PC assembly jig to the frame. These
couplings keep the PC assembly jig from
detachingfromtheframe.
Positioning of the lower
corners of the PC Assem-
bly Jig in the toothed gui-
deslocatedontheframe.
Positioning at 80° angle Positioning at 90° anglePositioning at 70° angle
Turn the knob to remove the middle bri-
dge.
PracticaluseofPCAssemblyJigwithPCBoardinplace. Unsoldering of components carried out with PC Assem-
blyJiginverticalpositions.
Foam rubber-lined lid for holding compo-
nents in place. May be raised by applying
pressuretofrontbuttons.
Easy to unslot and detach various parts.
(Frame-PC holder unit-component-Press
Lid).
PC board assembly jig can be raised by tur-
ninglateralknobs.Self-adjustmenttoframe
atrightworkingangle,afterunitraising.
Using pc board assembly jig
in vertical position