Datasheet

www.ideal-tek.com
swiss made
This document contains information based on average values as obtained from the results of laboratory tests and observations made on the material.
Ideal-Tek SA declines all responsibility from an improper use of the product described in this document.
Engineering plastic type CF
TECHNICAL DATA SHEET
General notes:
» PA66/CF30 polyamide 66 reinforced with 30 wt% carbon bre
» heat stabilized
» very high rigidity, excellent tensile and exural strength, fatigue and creep resistance
» low friction, self lubricating properties, excellent wear and abrasion resistance
» good heat capability
» good chemical resistance (oils, grease, fuels, non polar solvents); not resistant to strong acids, alkalis and hot
water or steam
» ESD safe material, (avoid powder attraction, sparks generation, ignition sources)
» very low coefcient of linear thermal expansion
» typical applications include handling of sensitive components and devices (electronic components, micro-mechanical
parts, glass and ceramic substrates, capillary, etc.)
Temp. of de. under load (1.80 MPa)
256 °C
ASTM D648
Temp. of de. under load (0.45 MPa)
260 °C
ASTM D648
Vicat softening temperature (50°C/h 50N)
254 °C
ISO 306
Coef. of lin. therm expansion, normal
2,80 E-5/°C
ASTM D 696
Continuous Use Temperature
130°C
20’000 h
Short Time Temperature
190°C
Flexural modulus +23°C
17000 MPa
ASTM D 790
Flexural modulus +60°C
12000 MPa
ASTM D 790
Flexural modulus +90°C
9800 MPa
ASTM D 790
Flexural modulus +120°C
8000 MPa
ASTM D 790
Tensile strength +23°C
210 MPa
ISO 527
Tensile strength +60°C
159 MPa
ISO 527
Tensile strength +90°C
134 MPa
ISO 527
Tensile strength +120°C
117 MPa
ISO 527
Rockwell hardness M
>100
ASTM D 785
Izod-Impact strength (notched) +23°C
70 J/m
ASTM D 256
Charpy-Impact strength (unnotched) +23°C
30 kJ/m
2
DIN 53453
Mechanical properties
Thermal properties
Surface resistivity
10
2
Ohm
100V
Comparative tracking index
<100 Volts
IEC 112
Decay time
< 0.1 sec
1000-10 V
Electrical properties