Datasheet

www.ideal-tek.com

swiss made

This document contains information based on average values as obtained from the results of laboratory tests and observations made on the material.

Ideal-Tek SA declines all responsibility from an improper use of the product described in this document.

Carbon steel type C

TECHNICAL DATA SHEET

General notes:

» Carbon style (material number 1.1221, Ck60, AISI 1060)

» contains from 0,57-0,65 wt% carbon

» magnetizable

» will be hardened by heat treatment, max. hardness 57 HRC

» poor resistance to corrosion

» used where strength and/or hardness are of primary concern

» typical applications include tweezers and cutting tools for the electronic industry, watch-makers, jewelers applications

Composition

Density 7.9 g/cm

Hardness, Vickers 700 HV

Tensile strength, ultimate 850-1000 MPa

0.2% Yield stress 500 MPa

Modulus of elasticity 200 GPa

Mechanical properties

Resistivity 0.18 E-4 Ohm.cm

Electrical properties

Coef. of lin. therm expansion 11 E-6/°C 20°C-100°C

Coef. of lin. therm expansion 12 E-6/°C 20°C-300°C

Specic heat capacity 0.502 J/(g∙K)

Thermal conductivity 52 W/(m∙K)

Thermal properties

Component Wt.% Component Wt.% Component Wt.%

C 0.57-0.65 Si 0.15-0.35 Cr ≤0.4

P ≤0.035 S ≤0.035

PAGE 1
swiss made TECHNICAL DATA SHEET Carbon steel type C General notes: »» Carbon style (material number 1.1221, Ck60, AISI 1060) »» contains from 0,57-0,65 wt% carbon »» magnetizable »» will be hardened by heat treatment, max. hardness 57 HRC »» poor resistance to corrosion »» used where strength and/or hardness are of primary concern »» typical applications include tweezers and cutting tools for the electronic industry, watch-makers, jewelers applications Composition Component Wt.% Component Wt.