Datasheet

www.ideal-tek.com

swiss made

This document contains information based on average values as obtained from the results of laboratory tests and observations made on the material.

Ideal-Tek SA declines all responsibility from an improper use of the product described in this document.

Nonferrous alloy type TA

TECHNICAL DATA SHEET

General notes:

» Titanium Grade 1 (unalloyed titanium)

» engineering materials with extraordinary combination of properties: relatively low density (4.5 g/cm3), good

mechanical properties and a very high melting point that allows the use at high temperatures (1600 °F, 870°C)

» good corrosion resistance at room temperature to air, marine and a variety of industrial environments

» good cold formability, high ductility

» fully non-magnetic (100%)

» generally it is used when in addition to the corrosion resistance, high strength-to-weight ratio is required

» bio-compatible (maintain cell integrity, no inammatory response)

» typical applications include handling of components in cleaning/chemical processes also at high temperature,

histology, biology, medicine, surgery

State annealed

Density 4.51 g/cm

Hardness, Vickers 190 HV

Tensile strength, ultimate 330 MPa

Tensile strength, yield 240 MPa

Elongation, break 30%

Modulus of elasticity 100 GPa

Mechanical properties

Resistivity 0.45 E-4 Ohm.cm

Electrical properties

Coef. of lin. therm expansion 9.2 E-6/°C 0°C-315°C

Specic heat capacity 0.52 J/(g∙K)

Continuos use temperature 350°C

Thermal conductivity 16 W/(m∙K)

Thermal properties

Component Wt.% Component Wt.% Component Wt.%

Ti 99.5 C ≤0.1 Fe ≤0.2

O ≤0.18 N ≤0.03 H ≤0.015

Composition