Installation Guide

SK618 / SK678 Instruction Manual – Rev 2017/06
www.idealinc.com
Page 12
4.4.3. Monitoring live audio
1. Dial 1#.
2. You will be able to listen to live audio from the room where the dialer is installed.
3. After 30 seconds, you will hear a beep, reminding you that if you do not enter another code
within 20 seconds, the call will disconnect. Dial 1# again at any time to extend room monitor.
4.4.4. Arming
1. Dial 5# once connected by phone.
2. You will hear three short beeps and the call will end.
3. If you hear five rapid beeps after the three short beeps, it means a sensor is open. The system
will give you 5 seconds to DISARM by dialing 6#. If you don’t, the system will arm and the alarm
cycle will immediately begin.
4.4.5. Disarming
1. Dial 6#.
2. You will hear a beep, and the call will end.
4.5. Operating by remote control
4.5.1. Arming
To arm the system using a remote control, press the LOCK button.
4.5.2. Disarming
To disarm the system using a remote control, press the UNLOCK button.
4.5.3. Panic
To immediately trigger the alarm using the remote control, press the PANIC button.
5. Other functions
5.1. Battery low indicator
The Battery Low indicator LED is flashing once every 1.5 seconds and
• No zone icon appears on screen: The battery in the alarm centre must be replaced.
• A zone icon flashes on screen: The battery in a sensor assigned to that zone is low and must be
replaced.
If batteries are low, false alarms may be triggered.
5.2. Alarm history
You can review the last 5 triggered zones.
1. In standby mode (the system is not ARMED and you have not entered programming mode),
press #/DOWN .
2. Once viewed, the text TRIGGERED will disappear from the screen