Installation Guide

SK618 / SK678 Instruction Manual – Rev 2017/06
www.idealinc.com
Page 11
2. You will hear a chime and the word HOME will appear on screen, followed by a 60-second exit
delay.
3. After 60 seconds, you will hear another beep. The system is now in HOME mode.
4.3.4. Exiting Home Mode
1. Press the HOME button once.
4.3.5. Panic
Pressing the PANIC button will trigger the alarm cycle immediately:
• If the siren is enabled, it will sound for 30 seconds on, 30 seconds off, then 30 seconds on.
• If the siren is disabled, the unit will beep 4 times.
• If remote notifications are configured, the dialing cycle will begin.
4.3.6. Deactivating the alarm
To deactivate the alarm once it has been triggered in any mode, enter your password followed by the
ARM/DISARM button.
4.4. Operating by phone
You can operate the system via telephone by either receiving a call after a triggered alarm, or by calling
in. In either case, you can use the following commands:
Function
Dial
Arm the system
5#
Deactivate alarm
6#
Disarm the system
6#
End the call
3#
Monitor live audio from the room
1#
4.4.1. Calling in
1. Dial the phone number of the line to which the alarm centre is connected
2. After the configured number of rings (see section 2.8 - Configuring the call-in feature), alarm
centre will pick up.
3. Enter your password on the telephone keypad. You will hear two beeps confirming you are
connected. If you enter the wrong password, the call will disconnect and the alarm centre will
issue 5 beeps.
4.4.2. Receiving an alarm call
When you receive a call following a triggered alarm, you will hear a sequence of beeps indicating the
triggered zone:
Beep sequence
Triggered Zone
One short beep, repeating
1 – 8 (not differentiated)
2 short beeps, repeating
24-hour zone
4 short beeps, repeating
Panic trigger