Instructions / Assembly

Rev. 10/05/2012
b. The " " icon will flash on the auto-dialer screen. (Fig.8)
c. Press ARM/DISARM button to confirm.
d. Using */UP or #/DOWN buttons to select call OFF followed by the
ARM/DISARM button to confirm.
e. Press PROG button five (5) times to exit the set-up mode.
8. TO PROGRAM AUTO DIALLING CYCLE
The auto-dialer has been factory pre-set for auto dialing for 3 cycles (When water is
detected the auto dialer will call ALL stored numbers 3 times). You can change this cycle
from 1 to 5 dialing cycles.
a. Enter password followed by PROG button six (6) times.
b. CYCLE will flash on the auto-dialer screen.
c. Press ARM/DISARM button to confirm.
d. Using */UP and #/DOWN buttons to select cycle times between 1 and 5
followed by the ARM/DISARM button to confirm.
e. Press PROG button four (4) times to exit set up mode.
This receiver/auto-dialer permits the person receiving an alarm call to listen-in to the
room where the dialer is located, or to call into the residence and listen.
9. TO PROGRAM CALL-IN RING DETECT CYCLE (how many rings before auto
dialer will answer.
The auto dialer has been factory preset to answer on the 5
th
ring.
The call-in ring detect cycle is for how many times you want the phone to ring before the
auto-dialer picks up. You can ARM/DISARM and monitor your home via the telephone.
a. Enter the password followed by the PROG button seven (7) times.
b. A will flash on the screen.
c. Press ARM/DISARM button to confirm.
d. Using the */UP
and #/DOWN buttons select 3, 5, 7 or 10 (which
represents the # of rings before the auto dialer picks up) followed by the
ARM/DISARM
button to confirm.
e. Press the PROG
button three (3) times to exit set-up mode.
NOTE: Regarding answering machines and call in feature. You cannot use an
answering machine with this feature. If you want to be able to call in to the auto dialer
you must program it to answer before your answering machine does. Example if your
answering machine answers after 4 rings, you must set the auto dialer to answer at 3 rings.
10. TO PROGRAM ENTRY DELAY TIME (Amount of time you need to deactivate
system once you have entered your residence)
The auto dialer has a factory preset entry delay of 20 seconds
a. Enter password followed by PROG
button eight (8) times.
b. ENTRY will flash on the auto-dialer screen.