Instructions / Assembly

Rev. 10/05/2012
2. Raise the antenna on the side of the unit so it points up (Fig.3). The antenna
should be vertically straight up for better reception.
3. The supplied telephone line splitter can be installed into your telephone wall
socket. (Fig.3a) or the LINE Jack of the auto-dialer (Fig.3b)
4. Now using the telephone wire supplied, insert the small clear plug into the LINE
jack on the auto-dialer and the other end into the telephone line splitter, (Fig.3a)
or insert your telephone line splitter into LINE Jack of main unit, then telephone
wire supplied into wall socket. (Fig.3b)
5. Your existing telephone line can now be inserted into the telephone line splitter.
(Fig.3a/b)
6. Connect the AC adaptor to the DC 9V jack on the auto-dialer. (Fig. 3c)
7. Wall mount option: Test the range of the unit before permanently installing.
Choose a suitable location, drill holes, using template provided and install
anchors and screws. Place the auto-dialer over the screws and slide it down to
secure it in place (fig 4).
SYSTEM AUTO-DIALER SET-UP
During any set-up, if no key is pressed for 10 seconds, the auto-dialer will automatically
exit set-up mode.
 All set-ups must be done in DISARM mode only. (the word ARM will not appear on
the screen)
 Your auto-dialer has a factory preset password of 0-0-0. This can be changed to your
own personal password.