Instructions / Assembly

Rev. 10/05/2012
FEATURES
• Received signal from wireless sensor activates auto-dialer and alarm
• 16 Digit large number display with date/time and function icon
• 9 zone icon for easy differentiating sensor location
- From Zone 1 to Zone 7, you can learn one wireless sensor for each zone to trigger the
system (Works in ARM mode only)
- Zone 8S you can learn up to 8 wireless sensors to trigger the system (Works in ARM
mode only)
- Zone 24H (24 hours stand by) you can learn up to 8 wireless sensors to trigger the
system in ARM or DISARM mode.
- Remote zone can learn 8 remote controls
• Room monitor by telephone function
• ARM or DISARM system by telephone
• Programmable security code, entry delay timing
• 5 emergency telephone numbers (up to 32 digits each) (only last 16 digits appear on
LCD screen)
• Programmable auto dialing cycle
• Records up to five triggered alarms for alarm mode
• Built-in flash memory to protect system data from power failure. If you have a power
failure and the battery dies, all info will remain in auto dialer except the date and time.
• Battery Low indicator
• Tone dialing only
• HOME mode function
• Built-in 105 dB alarm (with programmable alarm on/off)
• External extend trigger input terminal (compatible magnetic sensor)
• AC adaptor, 9V battery back-up and CR2032 battery (included)
• Wall mountable
• RF remote control for ARM/DISARM/PANIC
INSTALLATION
Auto dialer must be installed where it has access to a land phone line and electrical outlet.
1. Remove the screw from battery cover of main unit, install 9V battery included.
This is a back-up battery. This battery will keep the unit working in case of
power failure. (Fig.1) Install CR2032 battery included into the remote control
(Fig.2)