Instructions / Assembly

Rev. 10/05/2012
3. Once learn code was successful you must turn ON the AC Outlet Control
in order to receive the signal from the auto-dialer.
NOTE: You will hear a long beep to confirm that the learn code was successful. When
learn code is not successful you will hear 4 short beeps. If this happens please re-learn
again.
TROUBLE SHOOTING GUIDE
1. AUTO-DIALER WILL NOT ARM/DISARM
a. Make sure you have entered the correct password, if not, re-enter the password.
b. If it still does not work, perform the password reset following the instructions in
the “CHANGE PASSWORD” section to reset the auto-dialer.
c. Retry the ARM/DISARM function.
2. UNIT WILL NOT DIAL
a. Make sure the telephone line is connected properly.
b. Make sure the telephone numbers are stored correctly, include area code and 1 if
long distance.
c. Make sure you have not entered your home number where the auto-dialer is set up.
d. Make sure the auto-dialer is setup for auto-dial mode.
e. If auto-dialer does not receive a signal from the wireless sensor, perform the learn
code function following the instruction in the
“LEARN CODE FUNCTION FOR
WIRELESS SENSORS”
section.
3. FALSE TRIGGER
If any sensor sends false signals, ensure that the batteries are still in good operating
condition. Make sure that the gaps between the contact and sensor on the window and
door contacts are no more than a ¼” apart and that arrows are pointing towards each
other. Water detector is not in direct contact with some moisture or excess humidity.
TIPS
1. Make sure the full telephone number including area code has been entered
correctly.
2. Only suitable for single phone line. Not compatible with fax machines or multi
line telephones.
WARNING