Manualshelf

Instructions / Assembly

ManualsBrandsIDEAL Security ManualsElectricalAlarm Centre and Telephone Dialer
78910111213141516
Rev. 10/05/2012
Enabling and Disabling sensors when in HOME mode.
When in HOME mode all sensors will send signal to auto dialer and you will hear a
chime when a sensor is triggered. If you have one or more sensors that you do not wish to
have them send a signal to the auto dialer, example a contact on a patio door that is in
zone 3, then you would disable zone 3. Zone’s 1-7 can be disabled. All sensors in zone
8S must be enabled or disabled together. They cannot be separated. Zones 24hr and
REMOTE cannot be disabled. Factory setting is for all sensors on and will activate
chime when triggered. To turn off a zone follow these instructions.
a. Enter password followed by pressing the Home button.
b. Zone one will flash on the LED screen.
c. Using the */UP and #/DOWN buttons select the zone you want to
change the setting for.
d. Press ARM/DISARM button to confirm. Then using the */UP &
#/DOWN buttons select ON or OFF. Press ARM/DISARM button to
confirm.
e. Press the Home button once to exit home-setup.
5. PANIC BUTTON
a. If you press "PANIC" button on the auto-dialer or remote control , (if
learned) the ALARM will sound instantly for 30 seconds, then off for 30 seconds,
then on for 30 seconds and then off, and the auto-dialer will begin dialing the
stored numbers immediately, in either ARM or DISARM mode. If siren is set to
OFF you will hear 4 short beeps at the auto dialer and it will start dialing.
b. To stop the alarm sound and the dialing, enter password then press
ARM/DISARM button or press the DISARM button on the remote.
6. REMOTE CONTROL BY TELEPHONE OPERATION. (What you can do when
you receive a call from the system)
How to respond to a telephone alarm call.
a. Answer the call. You will hear one of the following:
1) 1 beep cycles is for zones 1-7 and 8S
2) 2 beeps cycles is for zone 24hr
3) 4 beeps cycles is for PANIC
b. You may enter the following codes on your phone key pad. Once code is entered
you will hear a beep for confirmation.
Function Press Keys
To Monitor Room 1#
To End the Call 3#
To DISARM the System 6#
HOME