Instructions / Assembly

Rev. 10/05/2012
automatically dial all the numbers stored, one by one, for the CYCLE (amount of
times the numbers are dialed) you have chosen. The receiver of the phone call
will hear one beep cycle for zones 1-7 and 8S, two beep cycles for 24hr zone
and four beep cycles for PANIC. The receiver of the call can then call a
neighbor, or take other appropriate action.
b. In ARM mode, if the auto-dialer is set to SIREN OFF, the numbers stored will be
dialed silently. No siren will be heard from the installed location. When the call is
answered you will hear the sequence of beeps and know which zone was triggered.
3. TO DISARM THE SYSTEM
a. Enter password followed by the ARM/DISARM button on the auto dialer. Or
press on DISARM button on the remote. (if learned)
b. You will hear one beep and the ARM icon will disappear from the auto-dialer
screen to confirm that the Auto-Dialer has been DISARMED.
NOTE: In the 24HR zone, the sensors will trigger the auto-dialer in ARM or
DISARM mode and start dialing the stored numbers the amount of times programmed
immediately and the siren will sound. If siren is set to OFF the unit will beep 4 times.
Before dialing, the auto dialer will detect if a phone line is connected, if no telephone
line is connected the auto dialer will beep 4 times then the alarm will sound without
dialing.
4. HOME MODE FUNCTION:
While at home you can set your auto-dialer to home mode. This will activate a chime
every time a sensor is triggered. If you have installed additional sensors you can also
program which zone will send signal to auto-dialer when triggered. The factory default is
all sensors send signal.
Turn system to Home Mode.
a. Press the HOME button once; (on left side of auto-dialer) you will hear a chime
and the word HOME will appear on the LCD screen.
b. Wait 60 seconds, you will hear a beep. System is now in home mode and will
chime if sensor is triggered.
c. When auto-dialer receives signal from zones 1-7 & 8S it will chime and show
which zone is being triggered on the auto-dialer LCD screen. After 5 minutes it
will reset itself and TRIGGER will disappear from the screen. If 24hr or panic
zones are triggered the auto dialer will start dialing the numbers programmed for
the amount of times specified if telephone line is detected. The auto dialer will not
reset itself it will keep showing the trigger until you press the HOME button.
d. Press the HOME button again to exit the HOME mode.
NOTE: Arming system while in HOME mode will deactivate HOME mode. After
disarming system you will have to press the HOME button again if you want to
return to HOME mode. In HOME mode the only thing the system does not do is
dial out or sound alarm for zones 1-7 and 8S. For zones 24hr and REMOTE when
triggered they will dial out.