Installation Guide

MAX 3/8"
MIN 1/4"
Handle Spindle Projected Length
DEADBOLT
DEADBOLT
STRIKE
OUTSIDE
HANDLE ASSY
LATCH
DEADBOLT
SPINDLE
LATCH
STRIKE
LATCH
STRIKE
SPACER
HANDLE SPINDLE
TIE DOWN SCREW
tapping screws
MAX 1/2"
MIN 1/4"
Deadbolt Spindle Projected Length
Handle & Latch Installation
1. Rotate the outside handle to the left or right
according to your door handedness.
2. Insert a handle spindle completely into the center hole
of the outside handle from the back side.
The spindle locks the handle in place and actives spring.
3. Place the outside handle assembly on door.
(If your door thickness is not standard then:
The spindle should project through inside
of door a max of 3/8" and min of 1/4".
You may have to cut off spindle.)
4. Place the latch on inside of door, fasten with
two machine screws. Do not over tighten screws.
5. Place the strike for latch along with a thick spacer
in between the strike and the jamb, align with pilot holes
on jamb, fasten with two tapping screws.
Deadbolt Installation
1. Insert a flat spindle from inside through
the center hole into the key lock.
Ensure spindle bottoms into key lock.
(If your door thickness is not standard then:
The spindle should project through
inside of door a max of 1/2" and min of 1/4".
Cut off the spindle beyond that length.)
2. Place deadbolt on inside of door,
fasten with two tapping screws.
Do not over tighten screws.
3. Place the strike for deadbolt on jamb,
align with pilot holes on jamb,
fasten with two tapping screws.
Thank you for your purchase.
If you require any information or installation assistance,
please contact our customer service.
Monday to Friday 7:30 am -3 pm (Eastern Time)
Tel: [phone] x 230
e-mail: [e-mail]
Updated instructions (if applicable) can be found at www.idealinc.com
IDEAL SECURITY INC.
LASALLE, QUEBEC, CANADA
CORAOPOLIS, PA., USA
PAGE 4 OF 4