Installation Guide

Fig 1
Fig 3.1
Fig 2.1
Fig 2.2
Fig 3.2
PAGE 2 OF 4
Template Placement and Drilling Instructions
1. Fold the template on the dotted line to 90
according to the handedness (left or right).
2. With the door in closed position, place folded template on inside of door
so that the SIDE A is against the jamb or metal z-bar, which ever projects out farther;
and SIDE B is on the inside surface of door. See Fig 1
3. Use a center punch to mark the position of all holes on SIDE A and SIDE B.
4. Drill pilot holes on all marked locations using drill bit of 1/16".
Drill pilot holes through door completely on SIDE B. Drill pilot holes 1" deep on SIDE A. See Fig 2.1
5. Enlarge 4 holes using a 5/16" drill bit through inside door skin only on SIDE B. See Fig 2.2
6. On outside door surface, enlarge 3 holes (upper three) using a 5/16" drill bit through outside door skin only.
See Fig 3.1 & Fig 3.2
7. On outside door surface, enlarge lower center hole to 7/8" using included hole saw blade
through outside door surface skin only. See Fig 3.1 & Fig 3.2