Installation Guide

DOOR

GLASS

JAMB

CHISEL OUT

THIS AREA

TO 3/8" DEEP

OUTSIDE

INSIDE

Template Placement and Drilling Instructions

1. Fold the template on the dotted line to 90

according to the handedness (left or right).

2. With the door in closed position,

place folded template on inside of door

so that the SIDE A is against the jamb

or metal z-bar, which ever projects out farther;

and SIDE B is on the inside surface of door.

3. Use a center punch to mark the position

of 3 holes on the inside surface of door on SIDE B.

Mark the position of 3 holes on the jamb on SIDE A (for strikes).

4. Using a 5/16” drill bit, drill 3 holes straight through

door from SIDE B.

5. Using a 1/16"drill bit, drill 3 pilot holes with depth of 1"

on the jamb on SIDE A.

6. Use a chisel to cut a rectangle hole 3/8" deep

on the jamb on SIDE A within the hatched area.

PAGE 2 OF 5