Operation Manual

SignalTEK NT 156875 Iss 2
User Guide Page 11
(2) When the Near-End Unit is connected
to an active network, using copper or
fiber cable, press the soft key DETECT
(F1) to display all options available (Fig
9
). IP tests can be run. For a full
description of these options see – Tests
menu description – Ethernet mode, page
25.
The detected services are PoE
(802.3af/at), ISDN, PBX and Unknown.
The connected Port nu
mber and LLDP
Power are displayed (when available.)
The IPv4 and IPv6 addresses assigned to
the tester are displayed (when available).
Fig 9
Fig 10
(3) When both the Near-
End Unit and
Remote Unit are connected to an active
network, using copper or fiber cables,
press the soft key DETECT (F1) to
display all options available (Fig 10). IP
tests and performance tests can be run.
For a full description of these options
see – Tests menu description – Ethernet
mode, page 28.
The detected services are PoE
(802.3af/at), ISDN, PBX and Unknown.
The IPv4 and IPv6 addresses assigned
to the tester are displayed (when
available).