Operation Manual

Testing Fibers

40 IDEAL

Testing in Auto Mode

8. Specify whether the unit must keep the fiber settings for all acquisitions

or not, as follows:

8a. Use the arrows to select the Keep parameters list, and then press

Select to open it.

8b. If you want the unit to reset the settings for each acquisition,

select No.

If you want the unit to always use the same parameters, select

Yes.

8c. Press Select to confirm.

Note: Even if you configured the unit to keep the parameters, it is possible to reset

the fiber settings by selecting No, and then starting an acquisition. If

desired, you can set back the option to Ye s to use the new settings for the

next acquisitions.

9. Press Auto Test to start the acquisition.

You can stop the acquisition at any time by pressing Auto Test once

again.