Operation Manual

Customizing Your OTDR

OTDR 19

Selecting a Printer

To print reports, you must configure the printer first. Your unit supports the

Printek 2” printer only and communicates with it via the infrared port

located on the top panel.

If you want to print on a network printer or if you want to print other type of

reports, you must transfer the desired files on a computer on which

OTDR Viewer is installed.

To select a printer:

1. Press Menu, select Setup > Unit, and then

press Select.

2. If necessary, use the left/right function

arrows until you see General, and then

display the pane (F1/F2 key).

3. Use the up/down arrows to select the Printer

list, and then press Select to open it.

4. With the current printer highlighted, use the up/down arrows to select

the desired printer, and then press Select to activate it.