Operation Manual

NaviTEK NT 151844 Iss 2
User Guide Page 9
HOME Screen (with network cable connected to Active Remote)
When the tester is connected to a cable that is terminated with an Active Remote, Autotest
runs an advanced Wiremap test that can detect split pairs and faults by pin. The HOME screen
displays a bar indicating the progress of the test. Select this bar and press ENTER to display
the Wiremap result screen. When the test is complete the result is saved (depending on the
Auto Save setting).
Active Remote ID number
Overall Cable Length
Result saved indication
Indicates the name of the
last saved result
Wiremap test bar
Indicates progress and final
test result (Green = PASS, Red
= FAIL)
Highlight the bar using the
cursor keys then press ENTER
to display the Wiremap screen
Test Result
Pair Lengths
Indicates the lengths of the
individual cable pairs
Overall cable length
FAULT
Press F2(FAULT) to display a
list of faults found
Test Status:
Ready to test
Test in progress
Test Passed
Test Failed
RUN
Press F1 (RUN) to re- run the
Wiremap test without saving a
result
SETUP
Press F3(SETUP) to set the
Wiremap parameters according
to the type of cable tested
Active Remote pin numbers
Tester pin numbers