Operation Manual

NaviTEK NT 151844 Iss 2
User Guide Page 24
Ports
(continued)
RJ45
Setup
802.1x - Enabled / Disabled
- EAP Method
EAP-MD5
EAP-MSCHAPV2
EAP-GTC
EAP-TLS
EAP-PEAP/MD5
EAP-PEAP/MSCHAPV2
EAP-PEAP/GTC
EAP-PEAP/TLS
EAP-TTLS/MD5
EAP-TTLS/MSCHAPV2
EAP-TTL/GTC
EAP-TTLS/TLS
- Username
- Password
- Certificate
- Import password
- Root/CA certificate
Results
Link pulse polarity – Normal or Inverted
Link pulse height – Normal or Low
Tests
Ethernet Mode - Ping4
- Ping6
- Trace Route4
- Trace Route6
- Hub Blink
- Netscan
- Loopback
- Auto (Ping DNS/Gateway/Internet, Trace Route,
Netscan)
Cable Mode - Wiremap
- Tone Generator
- Auto (Wiremap)
Service Detection
Detected Services - PoE (802.3af/at. Not Cisco pre-standard)
- ISDN S
- PBX
- Unknown
Optical
Supported SFPs
The following SFP types are supported. Use of other types of SFP is
possible but correct operation is not guaranteed.
SFP Type SX
Manufacturer Part # - Avago AFBR-5705Z / Apac LM28-C3S-TI-N-DD
Speed – 1Gbps
Fibre Type – Multimode
Wavelength – 850nm
Connector Type - LC Duplex
(continued)