Operation Manual

NaviTEK NT 151844 Iss 2
User Guide Page 16
Setup
Select SYSTEM to access the system setup:
Enter details of the test engineer and company information and logo (see Reports)
for inclusion in the reports
Access the JOBS menu
Set the menu language
Set preferences for auto off, backlight, length units, date and time format
Export or import setup information
Set the date and time for inclusion in the reports
Update the software. All settings and results will be lost. Save data to USB or
smartphone first.
View details about the system information of the tester
Reset to factory defaults. All settings and results will be lost. Save data to USB or
smartphone first.
Select TESTS to access the tests setup:
Set the details of the Wiremap test:
• Cable Type
o 2/4 Pairs
o 568A/568B colour scheme
• Shield Type
o UTP - Shield must not be connected for test to pass
o STP - Shield must be connected for test to pass
o UTP / STP - Test can pass if shield is connected or disconnected
• Custom NVP. To achieve accurate length measurements, set the NVP to
match the cable type
Set the details of the NET TEST:
• Primary / Secondary DNS and Gateway
o Disabled - The target is not tested as part of the NET TEST
o Auto - IP address of target is assigned by DHCP
o Manual - IP address of target is assigned manually or picked from the
Targets list by selecting
• Target
o Disabled - The Internet target is not tested as part of the NET TEST
o IP Address - Enter a numerical IP address for the Internet target or
pick from the Targets list by selecting
o URL - Enter a URL for the Internet target or pick from the Targets list
by selecting
• Ping Setup
o Count - Number of Ping attempts
o Pause - Interval between Ping attempts