Operation Manual

NaviTEK NT 151844 Iss 2
User Guide Page 11
NET TEST and Netscan
When an Ethernet link is established, or Autotest is pressed while a link is up, a NET TEST is
run automatically. This test consists of a series of Ping tests to multiple strategic targets in the
network, a Trace Route to a set destination, and a scan of all the hosts in the local network. To
display the NET TEST screen, select the test bar in the HOME screen and press ENTER.
Overall Test Result:
Not tested
Test in progress
Test Passed
Test Failed
Individual test result
Network map
Each tested network element is
shown by an icon that is
highlighted when the test result
is selected
DNS Ping results
The Secondary DNS is only
tested if the Primary DNS Ping
fails . Select and press ENTER
to display full details
Gateway Ping result
The Gateway is the route from
the local network to the
Internet. Select and press
ENTER to display full details
Internet Ping result
If this test passes, the tested
port has access to the Internet.
Select and press ENTER to
display full details
Trace Route result
Select and press ENTER to
display a list of all the hops
passed en route to the Internet
destination
Netscan result
Select and press ENTER to
display the Netscan screen
SETUP
Press F3 (SETUP) to access the
NET TEST setup screen
Host list
A list of all the hosts detected
in the local network
Netscan test result
IPv6 / IPv4
Press F1 to display IPv6 hosts
or IPv4 hosts
MAC / IP
Press F2 to display the MAC
address or IP address for each
host listed
Number of hosts found