Operation Manual

NaviTEK NT 151844 Iss 2
User Guide Page 10
HOME Screen (with live copper network connected)
When the tester is connected to a live copper-based network, Autotest detects the partner
Ethernet device at the far end of the cable and automatically tests the network connection
and displays information about it.
HOME Screen (with live fiber network connected - Pro only)
When the Pro tester is connected to a live 1Gb/s fiber network, Autotest automatically detects
the partner Ethernet device at the far end of the fiber. (There is no need to select copper or
fiber mode manually.) With the exception of power, the tests and information shown on the
HOME screen are as for copper.
Port rate and duplex
Select then press ENTER to
display the Statistics, VLAN
and Port screens
Power over Ethernet status
Select then press ENTER to
display the PoE test screen
MAC and ID of switch port and
port VLAN setting
Select then press ENTER to
display details of the nearest
switch, reported by CDP, LLDP
or EDP (if supported by the
switch)
NET TEST test bar
Indicates progress and final test result
(Green = PASS, Red = FAIL)
Select then press ENTER to display the
NET TEST screen in detail
NET TEST Status:
Ready to test
Test in progress
Test Passed
Test Failed
Tester IP Status:
IP address assignment in progress
Dynamic (DHCP) IP address
assigned
Static IP address assigned
IP address assignment failed
Select then press ENTER to display the
IP screen
Copper network connection
BLINK
Press F3 (MORE) then F2 (BLINK) to flash
the switch LED to assist in port identification
Tester VLAN ID
Received Optical Power
Select then press ENTER to
display the Optical screen
which gives details about the
SFP fitted and the transmitted
and received optical power
Fiber network connection