Operation Manual

MC2+—User Guide
EN-28 121800
• Ping Test to run a Ping Test.
• Modem Test to check whether the Modem, with a
specific Connection, is properly connected to the
Network.
Updating the MC2+ Firmware
-1- In the Update the MC2+ screen, browse to one of
the following files depending on the Annex you are
using.
• nsp.annexA.firmware.upgrade.img for
Annex A
• nsp.annexB.firmware.upgrade.img for
Annex B
-2- Select Update MC2+.
Wait until the Ethernet LED becomes inactive and
then lights up again.
-3- Check the firmware version by selecting Product
Information.
-4- Reset the MC2+. See Resetting your MC2+ on
page EN-29.
Using MC2+ in Through Mode
You can use your MC2+ to emulate an ADSL2+ modem
or router to connect a PC to the Internet.
-1- Switch on MC2+.
-2- Connect the RJ45 to RJ45 cable supplied to the
Ethernet port on MC2+ to the Ethernet port
of the PC.
or
Connect a suitable USB device cable to the USB port
on MC2+ to a suitable USB port on the PC.
-3- Start Internet Explorer or another suitable web
browser.
-4- Browse the Internet.
121800-4.book Page 28 Monday, March 5, 2007 10:09 AM