Operation Manual

Issue 4 - 02/07 EN-15
Using the MC2+ when connected to a PC
English
The following settings are displayed on all the WAN
Connection Type pages.
-8- Select the Apply button and wait for the page to
refresh.
If you want to create another Connection go to
Step 2 above.
-9- When you have completed all your entries, select
Save All from the Setup List (under System
Commands).
-10- Select the Save All button to confirm and wait for
MC2+ to save your settings.
Editing existing WAN Connections
You can only edit fields that are not greyed out.
Select and edit the fields as required.
 Note
You MUST re-enter the password, if applicable, before
you save your new settings.
-11- Select the Apply button to save your settings.
-12- Select Save All button to confirm and wait for
MC2+ to save your settings.
Setting up the LAN Configuration
The following describes how to set up the IP Address
details for the LAN (Local Area Network) configuration;
the Ethernet or USB side of the network. For details on
setting up the WAN Connections see Setting up New
WAN Connections on page EN-10.
-1- From the Homepage select the SETUP button.
-2- Select LAN Configuration from the LAN Setup
List.
-3- The LAN Configuration page is displayed.
VLAN Settings Description
VLAN User accessible on PPPoE only.
VLAN ID This not user accessible.
Priority Bits Description
This not user accessible.
121800-4.book Page 15 Monday, March 5, 2007 10:09 AM