Operation Manual

Issue 4 - 02/07 EN-13
Using the MC2+ when connected to a PC
English
Bridged You can configure MC2+ to simulate a bridged modem.
In Bridged mode, Ethernet frames are bridged over ATM
Virtual Circuits.The Ethernet frames are encapsulated
using either LLC Encapsulation or VC Multiplexing.
Because the Ethernet packets are bridged, the MC2+ only
has to pass the Ethernet packets to and from the ISP and
the local network. The IP Addresses of the local network
are assigned by the ISP either statically or dynamically.
CLIP Classical IP Over ATM as defined in RFC1577. This
provides the ability to transmit IP packets over an ATM
network. CLIP Encapsulates IP in an AAL5 PDU (Packet
Data Unit) using RFC1577 and it makes use of an ATM
aware version of the ARP protocol.
-4- Enter a unique Connection Name.
This cannot begin with numbers, it must contain
valid characters and no spaces.
-5- Select and enter a VPI and VCI to match the
network settings.
DHCP Settings Description
Encapsulation See Static Settings Table on page
EN 12.
IP Address If your DSL line is connected and your
DSL/ISP supports DHCP, select the
Renew button to retrieve these
settings.
Mask
Gateway.
Default Gateway
Bridged Settings Description
Encapsulation See Static Settings Table on page
EN 12.
CLIP Settings Description
IP Address See Static Settings Table on page
EN 12.
Mask See Static Settings Table on page
EN 12.
ARP Server. If you are not sure of the settings,
leave it as the default
0.0.0.0.
Default Gateway See Static Settings Table on page
EN 12.
121800-4.book Page 13 Monday, March 5, 2007 10:09 AM