Operation Manual

MC2+—User Guide
EN-12 121800
Static This is used whenever a known static IP address is
assigned. The Subnet Mask and the Gateway should also
be entered. You can also specify up to three DNS
(Domain Name Server) addresses to enable access to
other web servers.The valid IP Address range is from
0.0.0.0 to 255.255.255.255.
DHCP Dynamic Host Control Protocol. When this option is
chosen it enables the MC2+ to receive an IP Address
automatically from the DHCP server. With dynamic
addressing, a device may have a different IP address
assigned each time it connects to the network. Choose
this option when no authentication is required.
Static Settings Description
Encapsulation LLC and VC are two ways of
encapsulating multiple sessions. If
you are not sure of the settings, leave
it as the default (LLC).
IP Address Enter the static IP address to be
assigned to the WAN interface on the
MC2+. This is provided by your ISP.
Mask The Subnet Mask is used to determine
the Subnet to which the IP address
belongs.
Enter the Subnet Mask to be assigned
to the WAN interface on the MC2+.
The Mask is provided by your ISP.
Default Gateway The Default Gateway is a host to
which local computers send data that
is destined for non-local computers.
Enter the Default Gateway. This is
provided by your ISP.
DNS 1-3 The DNS service is used to translate a
Domain Name into a corresponding IP
Address.
Enter the Domain Name Services
values if provided by your ISP.
Mode Choose either
Bridged or Routed.
121800-4.book Page 12 Monday, March 5, 2007 10:09 AM