Operation Manual

Issue 4 - 02/07 EN-11
Using the MC2+ when connected to a PC
English
PPPoE & PPPoA
Settings
Description
Encapsulation PPPoA only. LLC and VC are two ways
of encapsulating multiple sessions. If
you are not sure of the setting to
choose, leave it as the default (LLC).
Username Enter the Username for your ISP
account.
Password Enter the Password for your ISP
account.
Idle Timeout This is only displayed when the
On-Demand option is enabled. This
specifies that the connection should
be disconnected if the link detects no
activity for the value entered.
Enter
0 if you want the link to remain
connected at all times.
Keep Alive This is only displayed when the
On-Demand option is disabled.
This value specifies the time to wait
without a connection to your provider,
before terminating the connection.
Enter
0 if you want the link to remain
active at all times. The default is
0.
Authentication This defines the authentication
protocol for your ISP. The default is
CHAP.
MTU Enter the Maximum Transmission Unit
for the DSL connection. The default is
1500.
On-Demand Select to enable on-demand
connectivity to the internet. Your
internet connection will be
disconnected if no activity is detected
after the specified timeout value. The
default is disable.
Default Gateway Enable to set this connection as the
default gateway in the routing table.
Enforce MTU PPPoE only.
Debug Select to enable PPP connection
debugging facilities.
121800-4.book Page 11 Monday, March 5, 2007 10:09 AM