Operation Manual

Issue 4 - 02/07 EN-7
Using the MC2+ when connected to a PC
English
Using the MC2+ when connected to a PC
Before you can start testing, you must configure MC2+ to
match the network you are going to test. MC2+ can store
up to 8 configurations. This includes any pre-set
configurations you have requested to be supplied from
the factory.
Warning
MC2+ can be used as a Router. In this mode it can
generate IP addresses using the DHCP protocol. This can
cause conflicts with other network equipment. Do not
connect MC2+ to an IP network unless you fully
understand how to configure the DHCP server, and the
effect that a DHCP server may have on your network, to
avoid these possible conflicts.
When you connect MC2+ to a network it will search the
stored configurations and choose a configuration to
match the network to be tested if available. Switch on
MC2+.
 Note:
Please wait approximately one minute for MC2+ to
initialise its software before connecting to the PC.
-1- Connect the RJ45 to RJ45 cable supplied to the
Ethernet port on MC2+ to the Ethernet port
of the PC.
or
Connect a suitable USB device cable to the USB port
on MC2+ to a suitable USB port on the PC.
 Note
If you want to use the USB port you must install the
MC2+ Driver from the User Information CD supplied.
-2- Start Internet Explorer or another suitable web
browser and enter the following URL:
http://192.168.1.1
This connects the PC to your MC2+ ready for
testing.
121800-4.book Page 7 Monday, March 5, 2007 10:09 AM