Operation Manual

MC2+—User Guide
EN-6 121800
PPP/IP
Indicator
LED
When this LED is lit it indicates that a PPP connection has
been established and an IP address has been assigned
successfully to MC2+ from the network.
 Note
Not all splitters (microfilters) pass line voltage
information through to the ADSL port.
Reset
Button
This only to be used if MC2+ has malfunctioned.
Connecting MC2+ to a Power Supply
MC2+ can be either battery powered or mains electricity
powered giving total flexibility for most testing sites and
situations. See Batteries on page EN-1 for more
information.
Fitting and Using Batteries
-1- Push the lower end of the tester out of its protective
rubber case.
-2- Remove the battery compartment cover.
-3- Insert 4 x AA batteries.
Warning
Make sure that you insert the batteries correctly.
-4- Refit the battery compartment cover.
-5- Refit the protective rubber case.
-6- Set the power switch to ON .
-7- Make sure that the Power LED is lit.
If the Battery Low Warning LED is lit, see
Batteries on page EN-1 for more information.
Fitting and Using the Mains Electricity Adaptor
-1- Set the power switch to OFF .
-2- Push the mains adaptor supplied into the Mains
Adaptor Connector on MC2+.
-3- Connect the mains adaptor plug to a suitable mains
electricity socket.
-4- Make sure that the Power Indicator LED is lit.
121800-4.book Page 6 Monday, March 5, 2007 10:09 AM