Operation Manual

Issue 7 - 10/08 EN-33
TOOLS
English
TOOLS
The TOOLS page enables you to:
• restart the MC2+
• update the tester firmware
• Save, transfer and restore configurations
• view the log and product information
• run Ping and Modem tests.
• Upload Results (Display Option MC2+ only).
-1- From the HOME page select the TOOLS button.
The TOOLS page is displayed.
Choose:
• System Commands to restart the MC2+ or restore
the factory defaults.
• System Log to view the system log.
• Update MC2+ to upgrade the MC2+ Firmware. See
Updating the MC2+ Firmware on page EN-33.
• Product Information to view the product information
for example, the MAC address and firmware version.
• Ping Test to run a Ping Test.
• Modem Test to check whether the Modem, with a
specific Connection, is properly connected to the
Network.
Updating the MC2+ Firmware
-1- In the Update the MC2+ page, browse to one of
the following files depending on the Annex you are
using.
• nsp.annexA.firmware.upgrade.img for
Annex A
• nsp.annexB.firmware.upgrade.img for
Annex B
-2- Select Update MC2+.
Wait until the Ethernet LED becomes inactive and
then lights up again.
-3- Check the firmware version by selecting Product
Information.
-4- Reset the MC2+. See Resetting your MC2+ on
page EN-48.
121800-7.book Page 33 Monday, October 20, 2008 4:11 PM