Operation Manual

Issue 7 - 10/08 EN-27
Disconnecting a Connection
English
Choosing the Default connection for
Stand-Alone Mode
-1- From the HOME page choose a saved Connection
from the list for MC2+ that you want to set as the
default.
-2- Select the Connect button.
A green screen LED indicates that the connection
has been successful.
-3- Select the SETUP button.
-4- Select Save All.
Disconnecting a Connection
-1- From the HOME page choose either:
All Connections or a Named Connection.
-2- Select the Disconnect button.
We recommend that you choose All Connections to
make sure that all the Connections are completely
disconnected.
Displaying Detailed Results
If the DSL status changes you will need to select the
Refresh button to update the page. The page will flash as
it refreshes during the updating process.
-1- Connect MC2+ to a PC by following the steps in
Using MC2+ when connected to a PC on page EN-8.
The HOME page is displayed.
121800-7.book Page 27 Monday, October 20, 2008 4:11 PM