Operation Manual

Issue 7 - 10/08 EN-23
Using MC2+ when connected to a PC
English
PPP/IP (Standard Option Only)
The following steps (-1- to - 5 -) and page are not
applicable if you have the Display Option MC2+. See
Ping Setup (Display Option Only) on page EN-24.
-1- The PPP LED Setup page is displayed.
-2- Enter the IP Address you want to ping.
The default IP Address is www.trendcomms.com.
-3- Enable Ping.
-4- Select the Apply button to save your settings.
-5- Select the Save All button to confirm and wait for
MC2+ to save your settings.
You must now switch off MC2+ and restart to enable
your settings.
You can now disconnect MC2+ from the PC as the
configuration has now been saved on MC2+.
For information on the PPP/IP LED see PPP/IP Indicator
LED on page EN-6.
Ping enabled
121800-7.book Page 23 Monday, October 20, 2008 4:11 PM